Align part to cone's side |
Marek Dedecius | 15.2.2010 10:51 |
What about the following procedure? 1. Snapped to the base of the cone (snap to the E point of the circle.) 2. I used the STC command and selected the angle-part. 3. Use the option "Rotate around, Dynamic" 4. For rotation, select the M point of the upper edge of the part, and then the outer edge of the upper base of the cone. If I understood your problem, the above should work well ... But perhaps you'd better send your file to support@varicad.com to make sure that you get accurate instructions. |
Discussion Forum
Align part to cone's side
To add questions or replies, please log in.
Filter:
Align part to cone's side |
Philip Myers | 15.2.2010 |
I have been working on this for an hour. I have a cone, 200mm dia at the top 300mm dia at the bottom 500mm long I want to add a part 15mmx15mmx 500mm long against the side. How can I do that without having to work out the angle and rotating the part. Is there a way to line the parts face against the cone? Thanks |
Procedure |
Philip Myers | 15.2.2010 11:43 |
Hi Marek, I sent off the file, but then followed your instructions and it worked, Thanks for the quick reply |
1