solution |
3dtech Tech | 15.12.2015 11:02 |
Another Make2D issue. It's all there somewhere. In Illustrator, the Rhino file is off the extents usually. Rhino only exports to version 8 and they are on version 16, I think. In Illustrator, immediately after opening the rhino exported AI file, do a select all, ctrl-A, cut, ctrl-x then paste ctrl-v -- the drawing lines (and there are many of them-- disconnected) will get pasted onto the illustrator page at the very center. If it's still too large, and AI complains, select a smaller output ratio in Rhino. Meters to mm or inches to mm, or 1 inch to .25 inch, for example. [url]http://vexmatech.com[/url] |
Discussion Forum
Defing 3d box with 2 points
To add questions or replies, please log in.
Filter:
Defing 3d box with 2 points |
Detlev Reppin | 5.2.2014 |
It is a considerable waste of time that one has to specify x, y and z every time I need to patch something with a box. Why is it so hard to implement a feature to define a box by its diagonal? |
1