Counter clockwise thread |
Detlev Reppin | 17.9.2014 14:19 |
since it is not explicitly stated that your inserted thread is clock wise, you could probably just annotate your dimension? |
Discussion Forum
Counter clockwise thread
To add questions or replies, please log in.
Filter:
Counter clockwise thread |
Cédric Dannemark | 17.6.2014 |
Hello, I'm currently testing VariCAD. I would ike to draw M14x1 _counter clockwise_ threaded holes but i did not suceeded yet... theres is no infos about it in the manual. Can you help ? Best regards. |
1