further questions with constraints |
Daniel Barna | 13.6.2009 17:57 |
Hi, similarly to Leo, I am trying to get familiar with constraints. Did I understand correctly from the docs, constraints can only be defined between parts of the same boolean tree. Is that correct? If not, can the following be done? (or is planned?): I have two boxes, for example (A and B). I want a 1mm gap between them, but I am in the early phase of design, and the dimensions of these boxes change. Can I constrain the position of box B to be 1mm apart from the neighbouring wall of box A? |
Discussion Forum
Working with constraints
To add questions or replies, please log in.
Filter:
Working with constraints |
Leo Walton | 16.5.2009 |
Hi just trying to get familiar with constraints in the new varicad version 2009 1.04 . Is it possible to constrain the relationship between two parts ? I have only found cutting and adding constraints. Is it possible to constrain say a shaft and a bearing center. If I constrain add the colours become the same so I take it constraint is only for a single piece ? |
constraints between solids |
VariCAD Support | 8.12.2009 16:24 |
This feature can be expected soon. It is scheduled to be included in VariCAD 2010 2.0. |
1