Section |
Thorsten Stueker | 1.10.2009 15:04 |
I had the Same or many Parts in Varicad as well as self made Parts and importet Step Geometry. I think it is a kernel Matter of Varicad wich has to be changed. Unless there is no chance to make the Section View correct there will also net be a chance to make the needed drawings correctly. You are than a bit out of the Position wich is - sometimes - making a Problem if the Dimensioning in this Case is manufactoring Reference. |
Discussion Forum
Unable to generate cross section
To add questions or replies, please log in.
Filter:
Unable to generate cross section |
Ormund Williams | 22.7.2009 |
I designed a hydraulic manifold and needed to generate cross sections of the 3D model. Some of the cross sections work but others will not work unless I move the sectioning plane slightly. Is any one else experiencing difficulty generating sections? Have I run up against a VariCAD limit? |
1